ATA PTX-4 Replacement Remote for Compatible Garage Door 301 V1 V2

• Free Battery
• Free Keychain
• Heavy Duty Design
• In-built Battery
• Button Protector

• Transmitter Frequency: 433 MHz
• Battery: 27A 12V required
• Coding Type: Rolling
• Control up to 4 doors

Programming a remote via the motor/receiver

1.Some garage motors have a plastic cover which covers the buttons, please remove this cover.

2.Press and hold the blue Door Code button on the motor or the SW1 or SW2 button on the receiver board (do not let go of

this button).

3.Press the new remote’s button which you would like to use to control the door for two seconds.

4.Release the button on the new remote and for two seconds. Press the same button on the remote again for two seconds.

5.Release the Door Code or SW button from the motor/receiver.

6.Press the new remote button to test operation of the door.

Deleting all remotes from the motor

1.Turn the power off to the motor from the power socket.

2.Press and hold the Door Code or SW1 button on the motor.

3.Turn the power back

on, whilst still holding the Door Code button. The Door Code LED

will illuminate after a few seconds to indicate the memory has been cleared.

4.Release the Door Code button and test your remote to ensure it has been deleted and

it should not operate the door.

Programming a new remote to a gate via original remote

1.Stand within 1-2 meters of your gates control board.

2.Press the button on your original remote to either open/close the gate.

3.Immediately after door begins to move, insert a pin into the center coding hole of the original remote located in the center of the four buttons. The LED light of the remote will illuminate when successfully pressed and ensure the light is illuminated for at least

2 seconds.

4.Remove the pin from the original remote.

5.On the new remote push and hold the new button you wish to operate the gate for 2 seconds.

6.Release the button for two seconds.

7.Push the same button again on the new remote for 2 seconds.

8.Wait 10-15 seconds and test the new remote

WARNING: Keep button batteries out of children’s reach:
• Keep coin-sized button batteries and devices out of sight and out of reach.
• Examine devices and make sure the battery compartment is secure.
• Dispose of used button batteries immediately. Flat batteries can still be dangerous.
• If you suspect a child has swallowed a button battery, immediately go to a hospital emergency room. Do not let the child eat or drink and do not induce vomiting.
• Call the Poisons Information Centre on Australia 13 11 26 or New Zealand 0800 764 766 for additional treatment information.
• Tell others about the risk associated with button batteries and how to keep their children safe.

ATA PTX-4 Replacement Remote for Compatible Garage Door 301 V1 V2